Project Description

Heyco-Flex™ Quick Twist Conduit Fittings (90° Sweep)

Heyco-Flex™ Quick Twist Conduit Fittings (90° Sweep)
Spec Sheet Button

Heyco-Flex™ Quick Twist Conduit Fittings (90° Sweep)

For use with Heyco-Flex™ I and II Conduit and Tubing

90° Sweep, Snap-In and NPT Hubs

  • One-piece solution with smooth internal surfaces provides for easier wire routing, protection, and installation around corner angles.
  • Easy, permanent assembly: the installer twists the tubing over the connector ferrule. • Unique locking fingers accommodate various panel thicknesses.
  • All nylon construction is resistant to salt water, weak acids, gasoline, alcohol, oil, grease, and common solvents. (This feature is not assessed by UL certification and testing.)
  • Suitable for a wide array of electrical applications:
    • Commercial and Industrial HVAC Systems
    • Motorized Equipment
    • Enclosed Power Sources
    • Garage Door Openers
    • Major Appliances
  • Finishing collars available to neaten rough cut tubing ends.
  • Assembly Tool available for assembling Quick Twist Fittings into HF1 and HF2 Conduit and Tubing. Snap-In Hubs
  • Snap-in Fittings are UL recognized for use with Heyco-Flex II Tubing.
  • Suitable for dry location only. NPT Hubs
  • NPT threaded fittings are UL approved for use with Heyco-Flex I & II Conduit and Tubing.
  • If using a tapped hole, Teflon® tape is needed on the threads of the connector, for all other applications an O-ring and Locknut are needed to attain liquid tight.
  • Locknuts not included. To order nylon or metal locknuts separately.

Heyco® Part Numbers:
8500, 8501, 8505, 8506, 8510, 8511

Contact RPD today to order.  317.883.6700